SN65C1168E-SEP Texas instruments

SN65C1168E-SEP

Уточнить цену

SN65C1168E-SEP

Уточнить цену

СРАВНИТЬ

В СРАВНЕНИИ

Уточнить цену

Описание

The SN65C1168E-SEP consists of dual drivers and dual receivers with ±12-kV ESD (HBM) and ±8-kV ESD (IEC61000-4-2 Air-Gap Discharge and Contact Discharge) for RS-422 bus pins. The device meets the requirements of TIA/EIA-422-B and ITU recommendation V.11. Some parameters do not meet all TIA/EIA-422-B and ITU recommendation V.11 requirements after 20-krad(Si) TID exposure.The SN65C1168E-SEP drivers have individual active-high enables.

VID V62/19606
Radiation hardened
- Single event latch-up (SEL) immune to 43 MeV-cm²/mg at 125°C
- ELDRS-free to 30 krad(Si)
- Total ionizing dose (TID) RLAT for every wafer lot up to 20 krad(Si)
Space Enhanced Plastic
- Controlled baseline
- Gold wire
- NiPdAu lead finish
- One assembly and test site
- One fabrication site
- Available in military (–55°C to 125°C) temperature range
- Extended product life cycle
- Extended product-change notification
- Product traceability
- Enhanced mold compound for low outgassing
Meet or exceed standards TIA/EIA-422-B and ITU recommendation V.11
Operate from single 5-V power supply
ESD protection for RS-422 bus pins
- ±12-kV human-body model (HBM)
- ±8-kV IEC 61000-4-2, contact discharge
- ±8-kV IEC 61000-4-2, air-gap discharge
Low-pulse skew
Receiver input impedance . . . 17 kΩ (typical)
Receiver input sensitivity . . . ±200 mV
Receiver common-mode input voltage range of
–7 V to 7 V
Glitch-free power-up/power-down protection

Number of receivers	2
Number of transmitters	2
Duplex	Full
Supply voltage (nom) (V)	5
Signaling rate (max) (MBits)	10
IEC 61000-4-2 contact (±V)	8000
Fault protection (V)	-10 to 15
Common-mode range (V)	-7 to 7
Number of nodes	32
Features	IEC ESD protection
Isolated	No
Supply current (max) (µA)	17000
Rating	Space
Operating temperature range (°C)	-55 to 125