CD4541B Texas instruments

CD4541B programmable timer consists of a 16-stage binary counter, an oscillator that is controlled by external R-C components (2 resistors and a capacitor), an automatic power-on reset circuit, and output control logic. The counter increments on positive-edge clock transitions and can also be reset via the MASTER RESET input. The output from this timer is the Q or Q\ output from the 8th, 10th, 13th, or 16th counter stage. The desired stage is chosen using time-select inputs A and B (see Frequency Select Table). The output is available in either of two modes selectable via the MODE input, pin 10 (see Truth Table). When this MODE input is a logic "1", the output will be a continuous square wave having a frequency equal to the oscillator frequency divided by 2N. With the MODE input set to logic "0" and after a MASTER RESET is initiated, the output (assuming Q output has been selected) changes from a low to a high state after 2N-1 counts and remains in that state until another MASTER RESET pulse is applied or the MODE input is set to a logic "1". Timing is initialized by setting the AUTO RESET input (pin 5) to logic "0" and turning power on. If pin 5 is set to logic "1", the AUTO RESET circuit is disabled and counting will not start until after a positive MASTER RESET pulse is applied and returns to a low level. The AUTO RESET consumes an appreciable amount of power and should not be used if low-power operation is desired. For reliable automatic power-on reset, VDD should be greater than 5V. The RC oscillator, shown in Figure 2, oscillates with a frequency determined by the RC network and is calculated using: Where f is between 1kHz and 100kHz and RS and 2RTC.

• Low Symmetrical Output Resistance, Typically 100 at V_DD = 15V
• Built-In Low-Power RC Oscillator
• Oscillator Frequency Range . . . DC to 100kHz
• External Clock (Applied to Pin 3) can be Used Instead of Oscillator
• Operates as 2 ^N Frequency Divider or as a Single-Transition Timer
• Q/Q\ Select Provides Output Logic Level Flexibility
• AUTO or MASTER RESET Disables Oscillator During Reset to Reduce Power Dissipation
• Operates With Very Slow Clock Rise and Fall Times
• Capable of Driving Six Low Power TTL Loads, Three Low-Power Schottky Loads, or Six HTL Loads Over the Rated Temperature Range
• Symmetrical Output Characteristics
• 100% Tested for Quiescent Current at 20V
• 5V, 10V, and 15V Parametric Ratings
• Meets All Requirements of JEDEC Standard No. 13B, "Standard Specifications for Description of ’B’ Series CMOS Devices"

Data sheet acquired from Harris Semiconductor

Technology family	CD4000
Bits (#)	1
Supply voltage (min) (V)	3
Supply voltage (max) (V)	18
Input type	Standard CMOS
Output type	Push-Pull
Supply current (max) (µA)	100
IOL (max) (mA)	4
IOH (max) (mA)	-4
Operating temperature range (°C)	-55 to 125
Rating	Catalog