SN54HC191-DIE Texas instruments

The SN54HC191-DIE is a 4-bit synchronous, reversible, up/down binary counter. Synchronous counting operation is provided by having all flip-flops clocked simultaneously so that the outputs change coincident with each other when instructed by the steering logic. This mode of operation eliminates the output counting spikes normally associated with asynchronous (ripple-clock) counters. The outputs of the four flip-flops are triggered on a low- to high-level transition of the clock (CLK) input if the count-enable (CTEN) input is low. A high at CTEN inhibits counting. The direction of the count is determined by the level of the down/up (D/U) input. When D/U is low, the counter counts up, and when D/U is high, it counts down. These counters feature a fully independent clock circuit. Change at the control (CTEN and D/U) inputs that modifies the operating mode have no effect on the contents of the counter until clocking occurs. The function of the counter is dictated solely by the condition meeting the stable setup and hold times. These counters are fully programmable; that is, each of the outputs can be preset to either level by placing a low on the load (LOAD) input and entering the desired data at the data inputs. The output changes to agree with the data inputs independently of the level of CLK. This feature allows the counters to be used as modulo-N dividers simply by modifying the count length with the preset inputs. Two outputs are available to perform the cascading function: ripple clock (RCO) and maximum/minimum (MAX/MIN) count. MAX/MIN produces a high-level output pulse with a duration approximately equal to one complete cycle of the clock while the count is zero (all outputs low) counting down, or maximum (9 or 15) counting up. RCO produces a low-level output pulse under those same conditions, but only while CLK is low. The counters can be cascaded easily by feeding RCO to CTEN of the succeeding counter if parallel clocking is used, or to CLK if parallel enabling is used. MAX/MIN can be used to accomplish look ahead for high-speed operation.

• Wide Operating Voltage Range
• Low Power Consumption
• Low Input Current
• Single Down/Up Count-Control Line
• Look-Ahead Circuitry Enhances Speed
  of Cascaded Counters
• Fully Synchronous in Count Modes
• Asynchronously Presettable With
  Load Control

Function	Counter
Bits (#)	4
Technology family	HC
Supply voltage (min) (V)	2
Supply voltage (max) (V)	6
Input type	Standard CMOS
Output type	Push-Pull
Features	Balanced outputs, High speed (tpd 10-50ns), Positive input clamp diode
Operating temperature range (°C)	25 to 25
Rating	Catalog