This 2-bit noninverting translator uses two separate configurable power-supply rails. The
A port is designed to track VCCA. VCCA accepts any supply voltage from 0.9 V to 3.6 V. The B port
is designed to track VCCB. VCCB accepts any supply voltage from 0.9 V to 3.6 V. This allows for
low-voltage bidirectional translation between 1-V, 1.2-V, 1.5-V, 1.8-V, 2.5-V and 3.3-V voltage
nodes. For the TXB0302, when the output-enable (OE) input is low, all outputs are placed in the
high-impedance state. To ensure the high-impedance state during power up or power down, OE should
be tied to GND through a pulldown resistor; the minimum value of the resistor is determined by the
current-sourcing capability of the driver. The TXB0302 is designed so that the OE input circuit is
supplied by VCCA. This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.
- Fully Symmetric Supply Voltages.
0.9 V to 3.6 V on A Port and 0.9 V to 3.6 V - VCC Isolation Feature — If Either VCC
Input Is at GND, All Outputs Are in the High-Impedance State - OE Input Circuit Referenced to VCCA
- Low Power Consumption, 5-µA Max ICC
- Ioff Supports Partial-Power-Down Mode Operation
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 4000-V Human-Body Model (A114-B)
- 1000-V Charged-Device Model (C101)
| Technology family | TXB |
| Bits (#) | 2 |
| Data rate (max) (MBits) | 140 |
| High input voltage (min) (V) | 0.81 |
| High input voltage (max) (V) | 3.6 |
| Vout (min) (V) | 0.9 |
| Vout (max) (V) | 3.6 |
| IOH (max) (mA) | -0.02 |
| IOL (max) (mA) | 0.02 |
| Supply current (max) (µA) | 10 |
| Features | Edge rate accelerator, Integrated pullup resistors, Output enable, Partial power down (Ioff), Vcc isolation |
| Input type | Standard CMOS |
| Output type | 3-State, CMOS, Push-Pull |
| Rating | Catalog |
| Operating temperature range (°C) | -40 to 85 |