DLPA2005 is a dedicated PMIC/RGB LED/Lamp driver for the DLP2010, DLP2010NIR and DLP3010
Digital Micromirror Devices (DMD) when used with a DLPC3430, DLPC3433, DLPC3435, DLCP3438, or
DLPC150 digital controller. For reliable operation of these chipsets it is mandatory to use a
DLPA2000 or DLPA2005.
- High Efficiency RGB LED/Lamp Driver With Buck-
Boost DC-to-DC Converter, DMD Supplies, DPP
Core Supply, 1.8-V Load Switch, and
Measurement System in a Small Chip-Scale
Package - Three Low-Impedance (30 mΩ Typical at 27°C)
MOSFET Switches for Channel Selection - Independent, 10-Bit Current Control per Channel
- 2.4-A Max LED Current for DLPA2005 Embedded
Applications - DMD Regulators
- Requires Only a Single Inductor
- VOFS: 10 V
- VBIAS: 18 V
- VRST: –14 V
- Passive Discharge to GND When Disabled
- DPP 1.1-V Core Supply
- Synchronous Step-Down Converter With
Integrated Switching FETs - Supports up to 600-mA Output Current
- VLED Buck Boost Converter
- Power Save Mode at Light Load Current
- Low-Impedance Load Switch
- VIN Range from 1.8 to 3.6 V
- Supports up to 200 mA of Current
- Passive Discharge to GND When Disabled
- DMD Reset Signal Generation and Power Supply
Sequencing - 33-MHz Serial Peripheral Interface (SPI)
- Multiplexer for Measuring Analog Signals
- Battery Voltage
- LED Voltage, LED Current
- Light Sensor (for White Point Correction)
- Internal Reference Voltage
- External (Thermistor) Temperature Sensor
- Monitoring and Protection Circuits
- Hot Die Warning and Thermal
- Low-Battery Warning
- Programmable Battery Undervoltage Lockout
(UVLO) - Load Switch UVLO
- Overcurrent and Undervoltage Protection
- DLPA2005 QFN Package
- 48-Pin 0.4-mm Pitch
- Die Size: 6.0 mm × 6.0 mm ± 0.15 mm
| Component type | PMIC/LED Driver |
| Chipset family | DLP2010, DLP2010NIR, DLP230GP, DLP230KP, DLP230NP, DLP3010, DLPA2005, DLPC3430, DLPC3432, DLPC3433, DLPC3434, DLPC3435, DLPC3438, DLPC3470, DLPC3478 |
| Rating | Catalog |
| Operating temperature range (°C) | -10 to 85 |